Connecting Other Equipment - Sharp SD-AS10H Operation Manual

Connecting other equipment

SD-AS10H
ENGLISH
Turn off the other equipment before making this connection.
" An optical digital cable, audio digital cable and audio cable are not included. Purchase a commercially available cable.
" If using an audio cable, purchase one without resistance. If you use an audio cable with resistance, sound volume will decrease.
" Plug in each cable fully to prevent noise interference.
! Audio connection to TV
You can listen to TV sound from the speakers by connecting the amplifier unit using
an optical digital cable or audio cable (not supplied).
Amplifier unit
Audio cable
(commercially available)
To listen to TV sound:
Turn the power on and press the FUNCTION button on the main unit.
Each press of this button changes the input in the order of "DIG1" "DIG2" "TV" "VCR".
DIG2: The audio input is switched to "AUDIO-DIGITAL IN 2 (OPTICAL)".
TV: The audio input is switched to "AUDIO-ANALOGUE TV IN".
You can also use the DIG FUNCTION (DIG1/DIG2) or FUNCTION (TV/VCR) button
on the remote control.
Note:
When using the optical digital socket, remove the cap first. After using
the socket, replace the cap.
E-59
TV
Optical digital cable
(commercially available)
To optical digital
audio output socket AUDIO OUT
L
To audio
R
output sockets
! Audio connection to VCR
You can listen to VCR sound from the speakers by connecting the amplifier unit using
an audio cable (not supplied).
Audio cable
(commercially available)
Amplifier unit
Audio cable
(commercially available)
To listen to VCR sound:
Turn the power on and press the FUNCTION button on the main unit.
Each press of this button changes the input in the order of
"DIG1" "DIG2" "TV" "VCR".
VCR: The audio input is switched to "AUDIO-ANALOGUE VCR IN".
You can also use the FUNCTION (TV/VCR) button on the remote control.
To record sound from the main unit, connect the VCR audio output sockets (amplifier)
with audio input sockets (VCR).
Notes:
" The audio VCR output sockets send signals coming from a DVD/CD, the tuner, au-
dio TV input sockets and digital audio input socket. Signals from the audio VCR in-
put sockets are not sent.
" When sending signals coming from the digital audio input socket via the audio VCR
output sockets on the unit, set the stereo mode to STEREO (see page 43). In the
multi channel mode, signals may not be sent properly. When sending signals from
the digital audio input socket to the audio VCR output sockets, the audio output lev-
el decreases. (Leave headphones unplugged whilst recording to avoid further level
decrease.)
05/3/17 SD-AS10H_SEEG_E.fm
To audio
output sockets
VCR
To audio
input sockets
TINSZA116AWZZ