System Installation - Sharp SD-AS10H Operation Manual

System installation

SD-AS10H
ENGLISH
Installation image (with optional accessories):
Front
speaker
(left)
Subwoofer
Surround
speaker
(left)
You can attach the floor speaker stand (optional accessory) to the front and surround
speakers.
(For details on the optional accessory, refer to page 65.)
! Magnetically shielded speakers
The front, surround and centre speakers may be placed beside or near the TV as
they are magnetically shielded. However, discolouration may occur depending on the
TV type.
If colour variation occurs...
Turn off the TV (with the power switch).
After 15 - 30 minutes, turn the TV on again.
If the colour variation is still present...
Move the speakers further away from the TV.
Refer to the manual of the TV for details.
Note:
The subwoofer is not magnetically shielded.
E-11
Front
speaker
Centre speaker (right)
Surround
speaker
(right)
! Placing the speaker system
The best surround effect will be achieved by placing each speaker at the same
distance from the listening position.
It is recommended to arrange the speakers as shown below.
Centre
Front
speaker
speaker (left)
Subwoofer
Surround
speaker (left)
Notes:
" The default distance is set to 2 m (6 feet). If speakers cannot be placed at equal
distances, refer to "Speaker delay setting" (see page 47).
" Place the TV halfway between the front speakers.
" It is recommended that the centre speaker be placed near the television.
" Place the surround speakers at a position just above the height of your ears.
" You can place the subwoofer anywhere you like. As it vibrates whilst reproducing
bass, place it on a stable, sturdy surface.
Same distance
Front speaker
(left)
Centre speaker
05/3/17 SD-AS10H_SEEG_E.fm
Front
speaker (right)
Default setting:
2 m (6 feet)
Surround
speaker (right)
Front speaker
(right)
TINSZA116AWZZ