Speaker Connection - Sharp HT-X1H Operation Manual

System connections (continued)
HT-X1H
ENGLISH

! Speaker connection

Make sure to leave the AC power lead disconnected when con-
necting the speakers.
To prevent accidental short circuits between
connect the speaker wires to the speakers first and then to the
subwoofer/amplifier unit.
When connecting speakers, match the colours of the back
label, tube for the speaker wire, and speaker terminal of the
subwoofer/amplifier unit.
1
Connect the wires to the speakers.
Example :To connect the left front speaker.
2
Connect the other end to the
subwoofer/amplifier unit.
Subwoofer/
amplifier unit
E-17
Caution:
" The supplied speakers are exclusively for the HT-X1H. Do
not connect them to other equipment, and do not connect
other speakers to the HT-X1H. It may cause malfunction.
" Do not mistake the
and terminals,
speaker wires. (The right speaker is placed on the right when you
face the subwoofer/amplifier unit.)
" Do not stand or sit on the speakers. You may be injured.
" Do not allow any objects to fall into or to be placed in the bass
reflex ducts.
" The speaker grilles are not removable.
" Do not short-circuit the speaker wire. If it
happens with the power on, the protection
circuit is activated and the system enters the
Label (white)
stand-by mode. In this case, check that the
Red speaker wire is connected correctly before
turning on the power again.
Tube (white)
Black
! Attaching the optional floor speaker stand
The front speakers and surround speakers support the optional floor
speaker stand (see page 66). Remove the original stand for each
Tube (white)
speaker using a screwdriver first. For details, refer to the manual for
the floor speaker stand.
Black Red
Speaker
terminal
(white)
Note:
Keep the removed speaker stands or screw in a safe place.
04/10/16
and , and right and left terminals of the
Incorrect
HT-X1H(H)E2.fm
TINSZA030SJZZ