Speaker Connection - Sharp HT-X1 Operation Manual

" Speaker connection

Make sure to leave the AC power cord disconnected when
connecting the speakers.
To prevent accidental short-circuits between
nals, connect the speaker wires to the speakers first and then
to the subwoofer/amplifier unit.
When connecting speakers, match the colors of the back label
on the speaker, to the tube for the speaker wire, and speaker
terminal of the subwoofer/amplifier unit.
1
Connect the wires to the speakers.
Example: To connect the left front speaker.
2
Connect the other end to the
subwoofer/amplifier unit.
Subwoofer/
amplifier unit
Caution:
! The supplied speakers are exclusively for the HT-X1. Do not
! Do not mistake the
and termi-
! Do not stand or sit on the speakers. You may be injured.
! Do not allow any objects to fall into or to be placed in the bass
Label (white)
Red
Tube (white)
Black " Attaching the optional floor speaker stand
The front speakers and surround speakers support the optional floor
speaker stand (see page 65). Remove the original stand for each
Tube (white)
speaker using a screwdriver first. For details, refer to the manual for
the floor speaker stand.
Black Red
Speaker
terminal
(white)
Note:
Keep the removed speaker stands or screw in a safe place.
connect them to other equipment, and do not connect other
speakers to the HT-X1. It may cause malfunction.
and , and right and left terminals of the
speaker wires. (The right speaker is placed on the right when you
face the subwoofer/amplifier unit.)
reflex ducts of the subwoofer/amplifier unit.
HT-X1
21