Attach Front/Rear Lat Cross Bar - Bowflex Xtreme 2 Assembly Instructions Manual

10
Step 12: Attach Front Lat Cross Bar to Upper Lat Tower
Figure 12
Locate the following items:
• Item #25 - Upper Lat Tower
• Item #26 - Front Lat Cross Bar
• Item #H - (2) 3/8" X 3" Hex Head Bolts
• Item #O - (4) 3/8" Washers
• Item #R - (2) 3/8" Nylock Nuts
Do not unwrap cables.
Align the bolt holes on the Front Lat Cross Bar (Item #26)
O
with the bolt holes on the bracket at the top of the Upper
Lat Tower (Item #25). Make sure to face the Cross Bar
Hooks toward the front of the Lat Tower.
Place (2) 3/8" Washers (Item #O) over the end of (2) 3/8"
X 3" Hex Head Bolts (Item #H) - one washer per bolt.
Affix the Front Lat Cross Bar to the Upper Lat Tower by
screwing the bolts through the aligned bolt holes. Place (2)
3/8" Washers and (2) 3/8" Nylock Nuts (Item #R) over the
ends of the bolts to secure them, as shown in Figure 12.
Do not tighten hardware from Step 12 at this time.
Step 13: Attach Rear Lat Cross Bar to Upper Lat Tower
Locate the following items:
• From Step 12 - Upper Lat Tower Assembly
• Item #27 - Rear Lat Cross Bar
• Item #J - (2) 1/2" X 5 1/4" Hex Head Bolts
• Item #Q - (4) 1/2" Washers, Large OD
• Item #S - (2) 1/2" Nylock Nuts
Do not unwrap cables.
Align the bracket on the Rear Lat Cross Bar (Item #27)
with the bolt holes on the Upper Lat Tower - see Figure 13.
Place (2) 1/2" Washers, Large OD (Item #Q) over the ends
of (2) 1/2" X 5 1/4" Hex Head Bolts (Item #J) - one washer
per bolt. Tightly secure the Rear Lat Cross Bar to the Upper
Lat Tower by threading the bolts through the aligned bolt
holes, and securing the ends with (2) 1/2" Washers, Large
OD and (2) 1/2" Nylock Nuts (Item #S), as shown in
Figure 13.
Tighten all hardware from Steps 12 & 13. When
completed, the Upper Lat Tower Assembly should
look like the figure 13 inset.