Instructions For The Installer - Smeg Oven Instructions For The User

13.1 Electrical connection
The identification plate bearing the technical data, serial number and brand
name is visibly positioned on the appliance. Make sure the voltage and the
cross-section of the power supply line match the specifications indicated on the
identification plate positioned in the storage compartment.
Do not remove this plate for any reason.
The appliance must be connected to earth in compliance with electrical system
safety regulations.
If the appliance is connected to the power supply network by means of a fixed
connection, install a multipolar cut-out device on the power supply line, in
accordance with the installation rules, located near the appliance and in an
easily reachable position.
If a plug and socket connection is being used, make sure that the plug and
socket are compatible. Avoid use of adapters and shunts as these could cause
overheating and risk of burns.
For operation on 380-415V3N~: use an H05V2V2-
F type five-core cable (5 x 2.5 mm
For operation on 380-415V2N~: use an H05V2V2-
F type four-core cable (4 x 4 mm
For operation on 220-240V~: use an H05V2V2-F
type three-core cable (3 x 6 mm
The end to be connected to the appliance must have an earth wire (yellow-
green) at least 20 mm longer than the others.
WARNING: The values indicated above refer to the cross-section of the
internal conductor.
64

Instructions for the installer

2
).
2
).
2
).
20 mm
20 mm
20 mm