Adding Internet Access Profiles; Deleting Or Modifying Internet Access Profiles - Sitecom Wireless Router User Manual

Table of Contents

Note:

When you click APPLY and TEST, the Wireless Router attempts to place a

call to your Internet Service Provider. Watch the Message Window for any messages.

If the test is successful, your users will be ready to access the Internet. If not, the

Wireless Router will try to give you enough information to let you know why the

connection is not successful.

If APPLY and TEST is successful, users on your LAN can now start to access the

Internet. However, it is required that these devices have also been configured to

obtain IP addresses automatically, as described in Chapter 2. Users may need to re-

boot their computers in order to obtain the DNS information obtained during the

APPLY and TEST operation.

Adding Internet Access Profiles

Step 1

If you want to add additional Internet access connection profiles, you need

to select Connection Profiles from the ARM Menu:

Configuration - Connection Profiles:

Then the following screen will show:

You should highlight New in the list, and then click NEXT, which will

lead you through the configuration as above.

To delete or modify a Connection Profile:

Step 1

Select Connection Profiles from the ARM menu.

Configuration - Connection Profiles

The following screen will appear.

3-11

Table of Contents

Do you have a question about the Wireless Router and is the answer not in the manual?