Activating/Deactivating Display Of Voip Status Messages; Check The Base Station Mac Address; Operating The Base Station; On The Pabx - Swisscom Aton CL700 IP User Giude

Operating the base station on the PABX
Activating/deactivating display
of VoIP status messages
If the function is activated, a VoIP status
code for your service provider is displayed.
Activate the function e.g. if you have prob-
lems with VoIP connections. You will
receive a provider-specific status code,
which supports the service when the
problem is analysed. You will find a table
with the possible status screens in the
appendix (page 86).
¢ ¢
v Ð
Settings
~
Enter the system PIN and press
.
§OK§
Show Stat. on HS
Select and press
Check the base station
MAC address
Depending on your network configura-
tion, you may have to enter your base sta-
tion MAC address, for example, into your
router's access control list. You can check
your base station MAC address:
v 5 5 O 2 Q
The base station MAC address is displayed.
a
Press and hold (idle status).
62
¢
Telephony VoIP
(½ = on).
§OK§

Operating the base station

on the PABX

The following settings are only necessary
when your PABX requires them; see the
PABX user guide. The settings only con-
cern fixed network connections.
You cannot send or receive SMS messages
on PABXs that do not support Calling Line
Identification.

Changing the dialling mode

You can set the dialling mode.
¢ ¢
v Ð
Settings
¢ ¢
Fixed Line
Select and press
Tone / Pulse
a
Press and hold (idle status).

Setting the flashing time

You can set the flashing time.
¢ ¢
v Ð
Settings
¢ ¢
Fixed Line
q
Select flashing time and press
.
§OK§
The current language is indicated by ½.
a
Press and hold (idle status).
Telephony
Dialling Mode
(½ = on).
§OK§
Telephony
Recall