Viewing The Network Mailbox Report; Using Several Handsets; Registering Handsets - Swisscom Aton CL700 IP User Giude

Hide thumbs Also See for Aton CL700 IP:
Table of Contents

Advertisement

Viewing the network mailbox
report
When a message is recorded, you receive
a call from the network mailbox. If you
have requested Calling Line Identification,
the display shows the network mailbox
number.
If you take the call, the new messages are
played back.
If you do not take the call, the network
mailbox number will be saved in the
missed calls list and the message key
flashes (page 30).

Using several handsets

Registering handsets

You can register up to six handsets to your
base station.
You can register your Aton CL300 V2
handset on up to four base stations.
Notes:
– If there are several handsets registered to
your base station, then you can use one to
make a call via the Internet and the other to
make a call via the Internet or the fixed net-
work at the same time. A maximum of two
internal connections can also be made.
– As a rule, all calls from a registered GAP
handset are dialled via the connection
types (fixed network or VoIP, see page 59)
that have been set up as Default Line. If you
want to establish a connection via the other
connection type, enter a "*" (star) after the
phone number. Example:
049891234567*.
– After registration, all the phone numbers
for the phone will be assigned to the hand-
set as receiving numbers. It will use the
fixed network number and the VoIP
number as sending numbers.
Registering another Aton CL300 V2
handset on the Aton CL700 IP
Before you can use your handset, you
must register it to a base station.
You must initiate handset registration on
the handset and on the base station.
If the handset was registered successfully,
the display will show the internal name for
the handset, e.g.
Int
the procedure.
On the handset
¢
¢
v
Ð
Settings
¢
Register H/Set
~
Enter the system PIN of the
base station (the default is
0000) and press
play shows e.g.
dure
and
On the base station
¤
Within 60 secs. press and hold the reg-
istration/paging key on the base station
(page 1) (min. 1 sec.).
The handset is assigned the lowest unas-
signed internal number (1–6). If several
handsets are registered to the base sta-
tion, the internal number is shown in the
display after registration, e.g.
means that the handset has been assigned
the internal number 2.
Notes:
If six handsets are already registered to the
base station, there are two options:
– The handset with the internal number 6 is
in idle status: the handset you wish to reg-
ister is assigned the number 6. The handset
that was previously number 6 is de-regis-
tered.
– The handset with the internal number 6 is
being used: the handset you wish to regis-
ter cannot be registered.
Using several handsets
1. If it does not, repeat
Handset
. The dis-
§OK§
Regstr.Proce-
Base 2
flash.
INT
2. This
47

Advertisement

Table of Contents

Troubleshooting

loading
Need help?

Need help?

Do you have a question about the Aton CL700 IP and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents