Installing Optional Hardware
Installing the Floppy Disk Drive
● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ●
The optional UD-FD01 floppy disk drive can be installed
to the bottom of the instrument by using the included
floppy disk drive case. Have a Phillips-head (+) screwdriver
ready.
Make sure that the screwdriver head snugly fits the
slots of the screw head. In particular, avoid
applying excessive force with an ill-fitting screw
driver; doing so may strip the slots and damage the
screws.
NOTE
None of the included screws are necessary for installing the UD-
FD01 to this Electone.
1
Remove the three backing papers from the
adhesive tape in the case, and fit the floppy
disk drive into the case.
Dual-sided
adhesive tape
14
224
ELS-01/01C Owner's Manual
2
Fold the USB cable inside the case as
shown.
3
Remove the USB unit from the Electone by
disconnecting the USB cable and removing
the four screws.
4
Put the USB unit on top of the UD-FD01
floppy disk drive as shown.
Align the four holes of
these two units.