Setting Up The Tv - Sony FD Trinitron WEGA KD-32FS130 Operating Instructions Manual

Setting Up the TV
After you have finished connecting your TV, use Auto Program to set up your analog and
digital channel lists. During Auto Program, the TV will automatically search for available
channels and program receivable channels.
_ After starting Auto Programi wait until the process is complete to avoid missing some channels that
are available, To re;program receivable Channels, run Auto Program again as described on page 4,2
(analog channels) and page 55 (digital channels).
1
Press the POWER button to turn on the TV.
The Initial Setup screen appears.
2 Press the CH+ button on the remote control or on the TV front panel to start Auto Program,
or press the CH-button to exit.
'S'_ The Initial setup screenappearseachtime you turn On the TV until you perform Auto Program.
3
Auto Program automatically creates a list of receivable analog channels. When completed,
a screen prompts you to continue searching for digital channels.
Searching for digital channels may take 50 minutes or more to complete. A progress bar is
displayed while the channel list is being created.
When Auto Program is finished, the lowest numbered channel is displayed.
To run Auto Program again at a later time
Use the Auto Program feature, using the TV's menus. For analog channels, see page 42.
For digital channels, see page 55.
To add digital channels
Use the Digital Channels/Add feature, as described on page 55.
To reset the TV to factory settings
1
Turn the TV on.
2
Hold down (_ on the remote control.
3 Press and release the POWER button on the TV front panel. The TV will turn itself off, then
back on.
RESET
4
Release C:D.
27