Sony FD Trinitron WEGA KD-32FS130 Operating Instructions Manual page 12

Programming the Remote Control
If you have video equipment other than Sony brand (or if you have a Sony DVD/VCR
combination unit) that you w_lt to control with the TV's remote control, use the following
procedure to program the remote control.
1 Check the list of "Manufacturer's Codes" on page 12 and find the three-digit code number
for the manufacturer of your component. If more than one code number is listed, use the
number listed first.
O0DES_T
2
Press CD.
_ VCR/DVD S_T/CABLE CODES_T
The CD and CD FUNCTION button flash when you press CZD.
3 Press v_ or S_LE FUNCTION button to indicate the type of component you want to
program with the remote control.
'2% You mUsi dO step 4, Within 10 SeConds Of Step 31 Or you must redo Steps 2 and 3.
4
Use the (_)-(_) buttons to enter the three-digit manufacturer's code number.
5 Press ESR.
6 To check if the code number works, aim the TV's remote control at the component and
press the green POWERbutton
(VCR/DVD, SAT/CABLE)
that corresponds with that
component. If it responds, you are done. If not try using another code listed for that
manufacturer.
/':_ if you have problems programming your remote Control, see the remote control troubleshooting
section on page 60.
11