Accessing The Electronic Program Guide (Epg); Accessing The Favourite Channels; Troubleshooting - Strong SRT 55 User Manual

PART 1 • English
2. Selected by number
Enter the channel number directly by pressing numeric buttons, and press
the OK button to select desired channel.
3. Selected by on-screen channels list
You can also select the required channel directly from on-screen channel
list. This is displayed using the receiver's main menu. See chapter 5.1.1 TV
Channel list in this manual for operation detail. Alternatively you can call
up channel list by pressing OK in viewing mode.
4. Selected by EPG
You can also select the required channel directly from electronic programme
guide (EPG). This is displayed by pressing EPG button on remote control.
See in the below chapter for operation detail.

6.2 Accessing the Electronic Program Guide (EPG)

1. Press EPG button to enter EPG menu.
2. Press numeric button [2] to switch between channel list, events schedule
of the selected channel and now/next events.
3. In the event schedule, press OK button to book the selected event, press
numeric button [3] to open the Detail menu for the selected event.
4. Press numeric button [1] to open the Booking list menu.

6.3 Accessing the favourite channels

1. Press OK button to enter channel list.
2. Press t or u cursor buttons to select the desired favourite group.
3. Press pq buttons to select the favourite channel.
A.1 TROUBLESHOOTING
There may be various reasons for the abnormal operation of the receiver. Check the receiver according to
the procedures shown below. If the receiver does not work properly after checking it, please contact the
dealer. Do NOT open the receiver cover. It may cause a dangerous situation and the warranty will get void.
Problem
IR sensor light not lit
No signal found
No picture or sound on
TV/VCR**
Possible cause
Mains lead unplugged/multipoint
connector switched off
Mains fuse blown
Bad connection of IR sensor plug
Aerial is disconnected
Aerial is damaged/misaligned
Out of digital signal area
Active antenna requires to switch ON
antenna power/external feed
Scart/ AV* is not selected on your TV
TV or VCR are not connected to main
What to do
Check mains lead /switch
multipoint connector on
Check fuse
Check connection
Check aerial lead
Check aerial
Check with dealer
Switch receiver's Antenna Power
ON/ connect external feed
Switch to correct TV input
Check mains lead
15