Table of Contents
Advertisement
PART 1 • English
Symptom
Remote control
doesn't work
Message "Antenna
circuit overload" on
screen
A.2 SPECIFICATION
Tuner
Input connector:
Input frequency range:
Bandwidth:
Input signal level:
Signal spectrum:
Antenna power:
Demodulation
Demodulation modes:
Guard interval:
Error correction:
Video decoder
Profile:
Input bit rate:
Aspect ratio:
Frame rate:
Resolution:
Audio decoder
Audio compression modes:
Audio modes:
Frequency response:
Sampling rate:
Cause
Batteries are discharged or not
correct installed.
Short cut in cable between
antenna and receiver or
antenna is out of service.
Type IEC60169-2 female, 75 Ohm
VHF: 174 MHz ~ 230 MHz
UHF: 474 MHz ~ 858 MHz
6, 7 and 8 MHz
-82 ~ -20 dBm
COFDM, transmition modes 2K/8K
5 V DC, max. 50 mA, short cut protected
QSPK, 16-QAM, 64-QAM
1/4, 1/8 1/16, 1/32
1/2, 2/3, 3/4, 5/6, 7/8
H.264/AVC Main Profile and High Profile@Level 3 for H.264/AVC and
MPEG-2 Main Profile@Main Level for MPEG-2
Max. 90 Mbit/s
4:3, 16:9, Pan & Scan, Letterbox
25 Hz for PAL and SECAM, 30 Hz for NTSC
720 x 576 for PAL and SECAM, 720 x 480 for NTSC
MPEG-2 Low Complexity AAC (LC-AAC), MPEG-4 High Efficiency AAC
(HE-AAC), MPEG-2 Layer II, MPEG-1 Layer I, MPEG-1 Layer II
Mono L/R, Stereo, Dolby Digital (dd)
20 Hz ~ 20 kHz, <+/-2 dB
60 Hz ~ 18 kHz <+/- 0.5 dB
32, 44.1, 48 kHz
Remedy
Check correct installation of the batteries.
Change batteries
Disconnect receiver from main power. Check
the cable between receiver and antenna.
Replace cable or/and antenna.
19
Advertisement
Table of Contents
