Sony QUALINA 002 Owner's Manual page 27

To switch the low-range frequency
response according to the recording
situation
Switch the low-cut switch inside the grip using
a pointed object such as a pen.
Recording situation
To reduce wind or breathing
noise
To attenuate noise due to
mechanical vibrations
To enhance sound clarity
Indoor recording
To eliminate the effect of wind or
breathing noise
Cover the microphone with the supplied wind
screen.
Slide on with the screw cut-
out pointing up.
Fasten the
screw.
Switch position
V
M
To check the remaining condition
Press BATT.
BATT lamp
Flashes brightly for a
moment and goes out
Lights up faintly or not
at all
The supplied battery will last for approximately 3 000
hours.
b Note
• When BATT is pressed during recording, a light
clock noise will be audible. The battery check should
therefore be performed before starting to record.
• If the internal battery is exhausted, the microphone
may not operate properly even with an external
power supply. Early replacement of the battery is
therefore recommended.
• When the supplied microphone cable is used to
connect an external microphone, monaural sound is
recorded on both left and right channels.
z Tip
• Sound may be recorded at lower volume with the
supplied external microphone than with the internal
microphone, thanks to the wide dynamic range of the
external microphone. This is not a malfunction. To
increase the volume of audio recording, adjust the
microphone volume level (p. 46).
Battery condition
Battery voltage is normal.
Replace the battery.
Getting started
27