General Problems - Sharp UX-485 Operation Manual

General problems

Problem
Information cannot be
programmed in the fax.
Nothing appears in the
display.
The machine does not
respond when you press
any of its keys.
Automatic document
feeding does not work for
transmission or copying.
Voice calls taken on an
extension phone are
interrupted by the fax.
No reception occurs when
polling is attempted.
Check and remedy
• Make sure the fax is plugged in and the imaging film
and paper have been loaded. (Programming is not
possible if the imaging film and printing paper have
not been loaded.) See Loading the Imaging Film and
Loading Printing Paper in Chapter 1.
• Make sure the power cord is properly plugged into a
power outlet.
• Connect another electrical appliance to the outlet to
confirm that it has power.
• If a beep sound is not made when you press the keys,
unplug the power cord and then plug it back in several
seconds later.
• Check the size and weight of the document (see
Transmittable documents in Chapter 3).
• The fax may interrupt during a voice call if the
reception mode is set to A.M. To prevent interruption
on a tone dial extension phone, press any three keys
on the extension phone after answering. (Note: Do
not enter the code to activate fax reception.)
• Make sure you have not run out of paper.
• Make sure the transmitting machine is in automatic
reception mode.
• If the transmitting machine has polling security, make
sure that your fax number has been entered both in
your machine and in the transmitting machine.
Problems and Solutions
99