Other Remote Operations - Sharp UX-485 Operation Manual

Comments:
When a remote command is
accepted by the machine, you will
hear one beep. If an incorrect
command is entered, you will hear
four beeps. In the latter case, re-
enter the correct command.
When entering a command, do not
pause longer than 10 seconds
between each digit. If you do, a 4-
beep error signal will be issued and
the digits entered up to that point
will be disregarded. In this case, re-
enter the command from the
beginning.
If you make two errors (causing
two 4-beep signals to be issued)
while entering your remote code
number, the line will be
disconnected. This prevents
unauthorized people from
attempting to guess your remote
code number.
If you pause for longer than 10
seconds before entering a
command, you will be
disconnected.
Remote Operations

Other remote operations

After listening to your messages, you
can do any of the operations
described below by pressing the
appropriate keys on the telephone.
Note: The following commands
cannot be entered while messages
are being played back. If you do not
want to wait until playback ends to
enter a command, first stop playback
by pressing "0" and "#", and then
enter the command.
Changing the fax reception
mode
Select a new reception mode by
pressing the keys as follows:
A.M. mode: "8", "1", and "#".
FAX mode: "8", "2", and "#".
TEL mode: "8", "3", and "#".
Caution: In TEL mode, you will not
be able to further change the
reception mode.
TEL/FAX mode: "8", "4", and "#".
1
8
(Example)
39