Selecting A Special Mode - Sharp MX-5000N Quick Start Manual

SELECTING A SPECIAL MODE

The procedure for selecting a special mode for fax is explained below.
The settings that must be selected vary for each special mode, however, the general procedure is the same. The
procedure for erasing shadows at the edges of the image when sending a fax is explained below as an example.
The side to be scanned must be face up!
Scan Internet Fax Fax USB Mem. Scan
Address Book
Scan: Auto
Original
Direct TX Exposure Auto
Sub Address
Resolution Standard
Address Review
Special Modes
(1)
File
Quick File
Auto Reception
Preview
Fax Memory:100%
Fax/Special Modes
Program Erase
(2)
Timer 2in1
Job
Mixed Size
Build
Original
Original
File
Count
Fax/Special Modes
Erase
Edge Centre Edge+Centre
Erase Erase Erase
Side Erase
1
2
PC Scan
Send:
A4 Auto
OK
Dual Page
Scan
1
Card Shot
2
Slow Scan
Mode
Quick File
OK
(4)
Cancel OK
Edge
15
(0~20)
mm
(3)
3
Place the originals.
When using the document glass, place the original with the
side to be scanned face down.
Select settings in the touch panel.
(1) Touch the [Special Modes] key.
(2) Touch the [Erase] key.
The erase settings will be configured to erase a width
of 15 mm around the edges of the original.
(3) Set the erasure width to 15 mm with the
keys.
The erase area is set to "Edge Erase" by default.
To select "Centre Erase", "Edge+Centre Erase", or
"Side Erase", touch the appropriate key.
(4) Touch the [OK] key.
Enter the fax number of the receiving fax
machine and press the [BLACK & WHITE
START] key.
Cancel scanning
75