Table of Contents
Advertisement
6. Restore HDD installed BRACKET-HDD.
(Assembly shall be done in the reverse procedure of disassembly as follows. Align the 5 fix-
ing points at the bottom with the BRACKET-HDD fixing holes respectively and push BRACK-
ET-HDD out of the product to align the screw fixing holes. Then, tighten the screws firmly.)
7. Check if BRACKET-HDD has been fixed to the product and connect both the power
supply cable and the signal transmission cable (IDE CABLE) to the HDD.
Signal Transmission
Cable (IDE Cable)
Power Supply Cable
2-6
Advertisement
Table of Contents
