Call Beats Data; Configuring Music-On-Hold - Gigaset 4170 isdn Operating Instructions Manual

Call beats data

Call beats data
Step
by
If an incoming call is made when the
Step
if both B-channels are seized owing to channel bundling, for example, then a B-
channel is split. The incoming call can be picked up and the Internet connection
is maintained with one channel.
If you have activated the
Info
the Internet with two separate RDT connections (e.g. with two PCs), one of the
two connections is immediately disconnected in the event of an incoming call.
Factory default:
G is pressed for menus.
1.
2. Press [
→
Call beats data

Configuring music-on-hold

The caller hears music-on-hold when put on hold by the base station rather
than the exchange (e.g. in the case of internal transfer). You should also note
the section on "Setting external/internal enquiry calls" on page 25. The following
settings can be selected:
Internal
External
Off
Press G for selection menus.
1.
Select using [
2.
→
Music on
Select using [
3.
28
Call beats data
Call beats data
Á
] and [OK] to select:
→ (
before menu item = ON / none = OFF).
The party on hold hears the base station's music on hold .
In this case, the music on hold is played by an external device.
An analog connection must also be configured as external music
on hold. If an analog connection has not been configured, the Ex-
ternal setting (through the analog connection) is not offered.
Please contact your specialist outlet to find out about adapters
for playing music on hold.
If the music on hold is not activated, no settings can be made.
Á ] and [OK]: Base Settings
hold.
Á
] and [OK]: required type.
Call beats data
function while at the same time surfing
is not activated.
→
Base Settings Settings
→
Settings
function is activated and
→
ISDN settings
→
System settings