Pnp/Pci Configuration Option - MATSONIC MS7112C Manual

Hide thumbs

Table Of Contents

Table of Contents

HDD & FDD

When this item is enabled, it defines system activities which can reset power-

saving mode timeouts to zero, or resume the system from a power saving mode.

This item is for hard disk and/or diskette drive activity.

DMA/master

When this item is enabled, it defines system activities which can reset power-

saving mode timeouts to zero, or resume the system from a power saving mode.

This item is activity through the system DMA controller.

Wake Up On LAN

This item allows you to enable or disable the LAN wake up function that is a

feature of this mainboard. When enabled, traffic through a network will resume

the system from any of the power-saving modes.

Modem Ring Resume

This item allows you to enable or disable the modem wakeup function that is a

feature of this mainboard. When enabled, traffic through a fax/modem will

resume the system from any of the power-saving modes.

RTC Alarm Resume

This item lets you install a wakeup alarm, which resumes the system from a

power saving mode at a fixed date and time. When the item is enabled, new

items appear which allow you to set the date and time of the alarm.

Primary INTR

This item acts like a master switch for all the interrupt items that follow. If this

item is set to ON, the all the following interrupts can be manually configured to

act as resets for the power saving timeouts. If this item is set to OFF, then all the

following interrupt items cannot be used to reset the power saving timeouts.

IRQX

These interrupt events can act as triggers to reset the power saving timeouts or

other system maintenance tasks. If you set an interrupt event to Primary, any

activity on that interrupt will reset the timeouts that use the primary timer (e.g. the

power saving modes). If you set an interrupt to Secondary, then any activity on

the interrupt will reset those timeouts that use the secondary timer (usually

background maintenance tasks). If you set an interrupt event to Disabled, any

activity on the interrupt will not reset the timeouts.