Install The Memory Modules - MATSONIC MS7112C Manual

5. Swing the locking lever down and hook it under the latch on the side
of the socket to lock it in place.
6. Locate the power connector for the processor cooling fan CPU FAN1.
If your processer has a cooling fan installed, connect the cable from
the cooling fan to CPU FAN1.

Install the Memory Modules

For this mainboard, you must use 168-pin 3.3V non-buffered Dual In-line
Memory Modules (DIMMs). The memory chips must be standard or
registered SDRAM (Synchronous Dynamic Random Access Memory).
The memory bus can run at 66 MHz , 100 MHz or 133MHz. If your
processor operates over a 100 MHz system bus, you must install PC-
100 or PC133 memory that also operates over a 100 MHz bus. If you
install a processor that operates over a 66 MHz bus, you can install
memory chips that operate at 66 MHz.
You must install at least one memory module and the first memory
module should be installed in slot DIMM1, the second in slot DIMM2 and
the third in slot DIMM3. If the modules use standard SDRAM, the
maximum capacity of each module is 128K. if the modules use
registered SDRAM, the maximum capacity is 256K.
The mainboard supports memory chips that have EC (Error Correction)
or ECC (Error Correction Code). If you install more than one module, the
modules should can have different capacities, but the memory chips
should all be the same type.
1. Locate the DIMM slots on the mainboard.
12
DIMM2
DIMM1
DIMM3