Pnp/Pci Configuration Option - MATSONIC MS7177CT User Manual

PNP/PCI Configuration Option

This option displays a table of items that configures how PnP
(Plug and Play) and PCI expansion cards operate in your
system. Both the ISA and PCI buses on the Mainboard use
system IRQs (Interrupt ReQuests) and DMAs (Direct Memory
Access). You must set up the IRQ and DMA assignments cor-
rectly through the PnP/PCI Configurations Setup utility;
otherwise, the mainboard will not work properly. Selecting
PnP/PCI Configurations on the main program screen displays
this menu:
CMOS Setup Utility – Copyright (C) 1984 – 2001 Award Software
PNP OS Installed
Reset Configuration Data
Resources Controlled by
x IRQ Resources
x DMA Resources
PCI/VGA Palette Snoop
Assign IRQ For VGA
Assign IRQ For USB
INT Pin 1 Assignment
INT Pin 2 Assignment
INT Pin 3 Assignment
INT Pin 4 Assignment
: Move Enter : Select
F5:Previous Values
PNP OS Installed (No)
Setting this option to Yes allows the PnP OS (instead of BIOS)
to assign the system resources such as IRQ and I/O address
to the ISA PnP device. The default setting is No.
Reset Configuration Data (Disabled)
If you enable this item and restart the system, any Plug and
Play configuration data stored in the BIOS setup is cleared
from memory. New updated data is created.
Resources Controlled By (Auto(ESCD))
You should leave this item at the default Auto(ESCD). Under
this setting, the system dynamically allocates resources to
Plug and Play devices as they are required.
PnP/PCI Configurations
[No]
[Disabled]
[Auto(ESCD)]
Press Enter
Press Enter
[Disabled]
[Enabled]
[Enabled]
Auto
Auto
Auto
Auto
+/-/PU/PD:Value: F10: Save ESC: Exit
F6:Fail-Safe Defaults
60
Item
Menu Level
Select Yes if you are
using a Plug and Play
capable operating
system Select No if
you need the BIOS to
configure non-boot
devices
F1:General Help
F7:Optimized Defaults