MATSONIC MS7112C Manual page 20

devices. If you connect two devices, you must configure one device
as Master, and one device as Slave. See the documentation
provided with the devices for information on this. To install more
drives, use another IDE cable and connect one or two devices to
IDE2.
Power Connector, Panel Connector & Case Fan
ATX1
1. Locate the power connector ATX1. Connect the power cable from
the power supply unit to ATX1. The connector is keyed so that it can
only be installed correctly.
2. If your system case has a built-in cooling fan, you can supply power
to the fan from the case fan power connector CASEFAN1. Connect
the power cable from the fan to CASEFAN1.
3. Locate the bank of switch and indicator
connectors PANEL. These connectors
provide control functions to your system
case. Use the illustration on the right and
the table below to make the connections.
Function
Power Indicator
Sleep Switch
Green Indicator
Keylock
Reset Switch
Speaker
Hard Disk Indicator
Power Switch
18
Pins
1+, 2+, 3
4, 5
7+, 8+, 9
10, 11
12, 13
15+, 16, 17, 18
20+, 21
22+, 23
CASEFAN1
PANEL
23
PANEL
Power SW 22-23
HDD LED 20-21
Speaker 15-16-17-18
Reset SW 12-13
KeyLock 10,11
Green LED 7-8-9
Sleep SW 4-5
Power LED 1-2-3
1