Silvercrest SL 80/2 100CI Operation And Safety Notes page 43

Drive motor
You can set the position of the motor, by rotating the motor in one of the
possible directions.
Press the arrow keys left (10) or right (11) to change the direction (East /
West) (setting on calling the motor control setting is "Stop").
Store position
When you make changes, you can save them under the indicated position
number (Select Position).
Press the "OK" key (14) to save.
Recalculate
On changing the settings in the "Motor control setting" menu, the motor must
recalculate them.
Press the "OK" key (14) to recalculate.
Set limit
You can define the current position as limit. The motor will then not rotate any
further than the defined position and thus detects the outer limit.
Press the arrow keys left (10) or right (11) to change the direction
(East/West).
Press the "OK" key (14) to save.
Clear limits
If the set limits are not correct, you can delete them again.
Press the "OK" key (14) to delete.
The East and West limits are deleted. It is not possible to delete
only one limit.
- 40 -