Silvercrest SL 80/2 100CI Operation And Safety Notes page 38

Select tuner
You can select the number and connection version of the tuner in this menu
item. If you have two separate satellite feeders, you have the option to
connect one tuner to each of them (recommended connection method, where
possible).
This connection method lets you use the full functionality of the set.
Select the setting "1 and 2" by using the arrow keys left (10) or right (11).
• If you have only one satellite feeder, you can use only one tuner.
Select the setting "1" or "2" by using the arrow keys left (10) or right (11).
• If you connect both tuners through one cable bridge (included in the scope
of supply):
Select the "LOOP" setting by using the arrow keys left (10) or right (11).
Link the connections IF OUT 1 and LNB IN 2 with the cable bridge, in
addition to the LNB IN 1 with a satellite feeder.
A cable bridge is a coaxial cable about 10 cm in length, with an F-
socket at each end. If the cable bridge is connected correctly, you
can do the following with only one connected satellite feeder:
- During a recording, change to the channels on the polarisation
plane on which the recorded program is present;
- Make a second recording within the polarisation plane of the first
recorded channel;
- If there are two recordings, change the channel on the
trasponders of the recorded channels.
All the channels of one polarisation plane are also available to you
through the picture-in-picture.
High signal quality for each is essential.
or
Press the "OK" key (14). A selection window appears.
Select the desired setting by using the arrow keys up (12) or down (13).
Confirm your selection by pressing the "OK" key (14).
- 35 -