Table of Contents
Advertisement
Page 12
6.
Auxiliary Parts
6.1 Battery
The 6 volt rechargeable battery supplied with your SD2200v2 will give power
to operate the detector for 14 - 15hrs after being fully charged.
These batteries may be recharged at any time during their discharge cycle.
It is very important to fully charge the batteries before storage. Do not
leave a battery fully discharged for longer than 1 day.
Only use 6v batteries as supplied. Never use a 12v battery as this
will damage the detecor. This damage is not covered by warranty.
6.2
Battery Chargers
Two types of battery chargers (mains and 12 volt car charger) are supplied
with the SD2200v2.
6.2.1
Charging Batteries
·
Turn the SD2200v2 off before disconnecting the battery.
·
Disconnect the battery cable from the detector and plug into the
appropriate charger. When charging, the battery must be kept in an
upright position.
6.2.2
Mains Charger
·
The mains charger will charge the battery from local mains (AC) power.
·
Plug the mains charger into a mains outlet. Switch the mains outlet
on. Check the charger nameplate; it will be rated at 1000mAh or
500mAh. The 1000mAh charger will recharge a completely flat battery
in approximately 10hrs while the 500mAh charger will take
approximately 20hrs.
·
Partially discharged batteries require a shorter period to recharge.
CAUTION
The Minelab SD2200v2
Advertisement
Table of Contents
