Operating Instructions - Minelab SD2200V2 Instruction Manual

Hide thumbs Also See for SD2200V2:
Table of Contents

Advertisement

Page 2
5.2

Operating Instructions

This section gives a detailed description of how to operate the SD2200v2
detector. The section 'Detector sounds' contains definitions of some terms
with which the beginner should be acquainted.
5.2.1
Detector Sounds
Threshold: This is the background sound produced by the detector. The
loudness of the background sound is set with the Threshold control. Set
this so that it can just be heard. The pitch of the threshold sound can be
set to your preference using the Tone control.
Object signal: This is an abrupt change of the pitch and volume of the
threshold sound. If the pitch drops first, then rises as the coil is passed
over a target, this generally (but not always) indicates a small target. If the
pitch rises first then falls as the coil is passed over a target, this generally
indicates a large target. The pitch variations can be different when operating
in Disc + ID mode (see section 5.2.9).
Ground noise: These are irregular noises that are difficult or impossible
to pinpoint when moving the coil over the ground. They are caused by
changing chemistry or "mineralisation" of the ground. While the detector is
in Tracking mode these effects are minimised.
5.2.2
Turning on the SD2200v2
Hold the coil away from the ground and metal objects and switch the Power
switch to "On".
Note: When the SD2200v2 is turned off, it saves important information
(like last tuning and ground balance settings) in its internal memory. If
detection is started in the same spot, the user should not have to re-tune
or re-ground balance the detector.
5.2.3
Set the Threshold Control
The Threshold control should be set so that background tone is barely
audible. It is important to note that small surface objects, as well as
large deep objects, will produce very small changes in the threshold
sound.
It is therefore important to set the Threshold control correctly to ensure
that these targets are heard. We suggest that you experiment with known
targets to assist in setting this and the other controls to suit your hearing.
The Minelab SD2200v2

Advertisement

Table of Contents
loading

Table of Contents