Operation; Quick Start Instructions - Minelab SD2200V2 Instruction Manual

Hide thumbs Also See for SD2200V2:

Table of Contents

Instruction Manual

Operation

These instructions can be followed by operators who are familiar with the

workings and general terminology of detectors. However, Minelab

recommends that as the SD2200v2 has new features and some of the

functions can differ from similar functions of other detectors, all operators

should read the Operating Instructions in section 5.2.

5.1

a) Switch the Power switch to "On".

b) Set the Threshold control so that sound can be heard in the

headphones.

c) Hold the detector at waist height with the shaft horizontal, so that the

coil is vertical. Keeping the coil vertical, slowly move it around your

body through a half-circle until the noise from interference is loudest.

Hold this position, keeping the coil motionless, and push the Tune button

once to start tuning function. Tuning takes approximately one minute.

A series of three beeps indicates that the best frequency has been

selected.

d) Rotate the Tone control to produce a threshold pitch that suits your

hearing.

e) Set the Channel switch to Both and the Audio/Boost switch to either

Shallow for small shallow targets, Deep for large, deep targets or

N (Normal) for general detecting. (see section 5.2.7)

Set the Iron Discriminate switch to the Disc position and turn the

Level Adjust to the middle of its range.

g) Ground balance the detector by pulsing the coil up and down and,

while coil is in motion, flick the Balance Mode switch from Fixed

to Track.

h) Your detector is now ready to be used.

Minelab recommends that you take time to read this manual thoroughly to

help get the most out of your new SD2200v2.

Page 1

Table of Contents