Table of Contents
Advertisement
Instruction Manual
8.
Maintenance
The SD2200v2 is a high quality electronic instrument. It is finely engineered
and housed in a durable container. Take care of it in the following way:
·
It is vitally important to keep the connectors dry and clean.
·
Do not expose the detector to high temperatures or leave in the sun
longer than necessary. Shading will help protect it. Avoid leaving it in
a closed vehicle, especially in the sun.
·
The coil housing will wear through if you scrub the ground with it
while searching. Minelab recommends that you use a replaceable
skid plate on the coils to protect them.
·
To prevent dirt entering between the coil and skidplate, you can use
a silk tape such as Leukosilk
The use of some other tapes, such as insulation tape, can result in
loss of performance.
·
The control box is not waterproof, even though it has been designed
to be water-resistant. Avoid getting it wet.
·
The coils are not waterproof. They are water resistant and may be
used in rain or wet conditions. Do not immerse in water.
·
The control box and Coils must not come into contact with petrol or
other oil-based liquids.
·
If any part of the detector comes into contact with corrosive
substances, including salt or salt water, it must be washed with
fresh water. Keep the unit dry and clean. To clean the detector use a
damp cloth with mild soap detergent. DO NOT use solvents.
®
, which is available from chemists.
Page 1
Advertisement
Table of Contents
