Minelab SD2200V2 Instruction Manual page 25

Hide thumbs Also See for SD2200V2:
Table of Contents

Advertisement

Instruction Manual
DO NOT leave the mains charger on for extended periods as
6.2.3
Vehicle battery charger
·
The car charger supplied with the SD2200v2 will charge the detector
battery from the cigarette lighter socket of your motor vehicle.
·
Plug the charger into the cigarette lighter socket and turn the ignition
switch to Accessories. This supplies 12 volt power to the cigarette
lighter socket. This voltage is reduced by the charger to 6 volt output to
charge the detector battery.
·
A red LED will flash while the battery is charging. When the battery is
flat the LED may flash fast enough so as to appear constantly on, as
the battery charges the LED will flash at a slower rate. Leave the battery
to charge for approximately 10hrs using this charger.
·
If the battery voltage of your vehicle drops below 11 volts, the charger
will stop charging. This stops the battery charger from flattening the
vehicle battery.
The 12 volt charger is designed for use with vehicles which have a
negative earth electrical system. Most cars made after 1970 will
have a negative earth electrical system. If you plug the charger into
a vehicle with a positive earth system, the fuse in the cigarette
lighter plug will blow and the LED will not light.
CAUTION
reduced battery life can result
CAUTION
Page 13

Advertisement

Table of Contents
loading

Table of Contents