Table of Contents
Advertisement
Page 8
j)
Fit the battery (12) into the battery bag (13).
k) Plug the headphones (17) into the socket in the cap of the battery.
l)
Put on the battery bag (13). Ensure that the Power switch on the control
box is set to "Off". Plug the connector on the bag cable into the Power
connector on the control box. This cable connects the battery and
headphones to the detector. The bungy cord (18) can be attached to
the knuckle on the shaft to take some of the weight when prospecting.
An adjustable hand strap on the handle allows you to relax and flex
your fingers without putting the detector down.
Figure 2 - SD2200v2 Battery Assembly
The Minelab SD2200v2
Advertisement
Table of Contents
