Vcr Installation - Panasonic TX-28DT30 Operating Instructions Manual

VCR INSTALLATION

Your new TV is supplied with programme position '0' set to receive an RF signal from your VCR, although a Scart connection is
preferable if the VCR is so equipped.
However, if for some reason your VCR is tuned to a different RF channel then you will not receive any picture or sound from your VCR
on programme position '0' of the TV. It will be necessary to either adjust the RF channel of your VCR (some VCR's allow adjustment of
their RF channel via their remote control unit) or to adjust the tuning of the TV's programme position '0' or both until it receives the RF
output channel of your VCR.
It is intended that this advice is used in conjunction with the instruction books for your additional equipment.
Use the AV1 Scart terminal for a VCR.
Use the AV2S Scart terminal for an S--Video VCR.
Use the AV2S Scart terminal for a Q--Link,
To tune your TV to the VCR
Switch on the VCR, insert and play a
pre--recorded tape with known content
On the TV, select programme position '0'
Open the Front panel flap
Press the F button repeatedly until
"Tuning mode" is reached
Press the -- or + button to access Tuning
mode
Press - - or + to begin searching for the
VCR playback
When the VCR playback is found, press
the STR button to store the programme
position
The programme position and channel
number indicators will flash to indicate the
station is being stored
To exit Manual Tuning, press the F
button
Notes :
D If picture patterning occurs on programme position '0' it
may be necessary to adjust the RF output channel of
the VCR, refer to the VCR instruction book.
or compatible VCR.
NEXTVIEWLINK
F
--/v
--/v
STR
F
41