Pc Connection And Modem Menus - Panasonic TX-28DT30 Operating Instructions Manual

PC CONNECTION AND MODEM MENUS

The PC Connection and Modem menus allow you to make adjustments to the communication
settings for the SERIAL and MODEM ports. You may wish to refer to the operating instruction books
Open the Setup menu
Move to DVB setup
Access DVB setup menu
Move to PC Connection or
Modem
Access the chosen menu
Make the required adjustments.
('OK' - - Store will be flashing)
Press the OK button to store the
settings
Press the EXIT button to exit
Baud Rate (bit/sec)
Number of Data Bits
Stop Bits
Protocol
Parity
Dialling
Prefix
None, 0~9
Redial attempts
None ~ 9
32
for your external equiment before changing these settings.
Sets the speed of transmission. Use the
highest speed allowed by the external
equipment.
Determines the number of consecutive
data bits to be sent. Select from either 7
or 8.
Determines the number of stop bits to
be used. Select from 1 or 2.
Determines whether a protocol should
be used. Select from None, Hardware or
Software.
Determines whether parity checking
should be used. Select from None, Odd
or Even
Modem only:
Select either DTMF (Tone) dialling or
Pulse dialling.
Many internal telephone networks
require you to dial a single digit before
dialling an "outside line". If the Modem
is connected to such a system, use the
Prefix function to enter the initial digit, for
example 9.
The Redial attempts function allows the
TV to automatically redial a number if a
connection cannot be made.