Configure The Sip Parameters - CyberData 10844 Operation Manual

Web Page Item
RTFM Announcement

2.3.4 Configure the SIP Parameters

Note
Note
Operations Guide
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
a
a.If you select No for RTFM Announcement, you will not hear a beep or associated RTFM audio.
However, the return to default settings function remains active. If you wish to return to default
settings, hold the RTFM button at least 20 seconds, then release the button.
3. After changing the parameters, click Save Settings.
1. Click SIP Setup to open the SIP Setup page
For specific server configurations, go to the following URL:
http://www.cyberdata.net/support/voip/ceilingspeaker.html
If the speaker is set up for MGROUPS, the SIP settings will be grayed out.
Table 2-6. Speaker Setup Parameters
Description
Enable/Disable the speaker tone (beep) and audio
associated with the RTFM switch.
Click on this button to save your configuration settings.
Click on this button to do an audio test. Generates a voice
message for testing the speaker audio quality and volume.
Link to the Network Setup page.
Link to the SIP Setup page.
Link to the MGROUPS Setup page.
Link to the Upgrade Firmware page.
Link to the Home page.
(Figure 2-9).
930095K
Installing the VoIP Ceiling Speaker
Configure the Speaker Parameters
CyberData Corporation
15