Table of Contents
Advertisement
E) BELT REPLACEMENT (MC-UL424)
Replace belt whenever beater bar stops turning or a burning rubber smell caused by excessive slippage occurs. Refer to
VACUUM CLEANER CONSUMABLES/ACCESSORIES (page 24) for part number.
1 1
Nozzle Hose
3
2
Locking
Tab
1
Turn off and unplug the vacuum
cleaner. Lay unit on floor with nozzle
flat as shown.
Remove nozzle hose from body by
(1) pressing in locking tab and (2)
sliding up and (3) out of retaining slot.
1 7
2
Place the vacuum in the upright
position standing on the handle.
Reinstall lower plate by (1) aligning
the tabs on the lower plate with the
slots in the nozzle and (2) rotating to
installed position. Ensure tabs
are locked into slots.
1 2
Always place paper under nozzle
whenever lower plate is removed to
protect floor.
Remove the four screws from the
lower plate.
1 8
Four Screws
Tabs
1
Slots
Lay unit on floor bottom up with
nozzle flat.
Install the four screws to the lower
plate.
Four (4)
Screws
- 17 -
1 3
Place the vacuum cleaner in the
upright position standing on the
handle. This will minimize wheel
interference when removing lower
plate.
Remove lower plate by rotating
upward.
1 9
1
2
Route nozzle hose to hose holder.
Align nozzle hose bracket with slot on
vacuum cleaner and slide down until
it clicks into place.
Return the vacuum cleaner to the
upright position before plugging into a
mains socket.
Advertisement
Table of Contents
