Table of Contents
Advertisement
HOW TO OPERATE YOUR VACUUM CLEANER
A) MAINS LEAD
1 1
Turn the mains lead quick release to
either side and down to release the
mains lead.
B) ON/OFF SWITCH
1 1
Moving parts! To reduce the risk of personal injury, DO NOT touch
the beater bar when vacuum cleaner is on. Contacting the beater bar
while it is rotating can cut, bruise, or cause other injuries. Always
unplug from electrical socket before servicing.
Use caution when operating near children.
1 3
Mains Lead
Quick Release
Detach the plug from the mains lead
and pull the mains lead off the mains
lead quick release.
On/Off
Switch
CAUTION
Plug
Mains Lead
To turn vacuum cleaner on or off, press on the on/off
switch.
CAUTION
To prevent damaging carpeted floors, tiled floors,
linoleum, etc. Do not leave the beater bar rotating in
the same place for too long.
- 7 -
1 3
Locking Notch
Mains Lead
Be sure the mains lead is locked
under the locking notch on the rear of
the handle.
Plug the mains lead into a 230-240
volt mains socket located near the
floor.
Note: To store mains lead, turn the
mains lead quick release to the
upright position, then wrap mains
lead loosely around mains lead
quick release and lower hook.
Refer to MAINS LEAD STORAGE,
page 6.
Advertisement
Table of Contents
