Table of Contents
Advertisement
SETUP PROCEDURE
Follow the procedures below for setup.
1. Press the Power Switch back to the OFF position.
Check that the Power Switch LED is off.
2. Set the MODE Switches as follows:
Select an operation mode using the MODE Switches on
the rear panel. See page 9 for details.
• Communication mode
This mode must be selected whenever this data multi-
plexer unit is used.
• Set the following in communication using the DATA
Port or RS485 terminal. Termination ON or OFF, full
duplex or half duplex.
• Set the type of sync signal to be output from the Data
Multiplex Unit.
Set it in supplying the sync signal from the VS/VD OUT
connector to other devices.
3. Set the UNIT Switch.
Set address (unit address, or camera addresses) using
the UNIT Switch on the front panel. The addresses to
be set vary depending on the communication mode
set. See page 10 for details.
4. Press the Power Switch down to the ON position.
Check that the Power Switch LED lights up.
5. Set parameters on the Setup menu.
Set parameters on the Setup menu as required to use
the Data Multiplex Unit. The contents of the Setup
menu vary depending on the communication mode
used. See page 11 for details.
8
Power Switch LED
Power Switch
UNIT
POWER
0
ON
1
OFF
ALARM
RESET
SUSPEND
SET UP
SET
ESC
2
3
4
Data M
Advertisement
Table of Contents
