Displaying The Setup Menu Of Camera Communication Mode; Communication Setup For Camera Communication Mode - Panasonic WJ-MP204 Operating Instructions Manual

Displaying the Setup Menu of
Camera Communication Mode
1. Check that the cameras and peripherals are connected
correctly and securely.
2. Switch all the system components on.
3. Press the SETUP/ESC button for 2 seconds or more.
The Setup menu appears on the monitor.
WJ-MP204 SETUP MENU X.XX
COMMUNICATION
SYSTEM
4. Move the cursor up or down pressing button 1 (C) or
button 2 (D).
5. Press the SUSPEND/SET button. The COMMUNICA-
TION menu or the SYSTEM menu appears on the moni-
tor as shown below.
COMMUNICATION
CAM ADDRESS
BAUD RATE
DATA BIT
PARITY CHECK NONE
STOP BIT
WAIT TIME
DELAY TIME
XON/XOFF
ALARM MODE
COMP/VD2/DATA
VS/VD INPUT
DAISY MODE
TERMINAL
• The following buttons are used with the Setup menu.
1 (C): To move the cursor down
2 (D): To move the cursor up
3 (–): To select a mode or parameter
4 (+): To select a mode or parameter
SUSPEND/SET: To enter the selections and display
the submenu for the item indicated by the mark
SETUP/ESC: To return to the previous menu.
16
19200
8
1
OFF
OFF
NOT USE
SYSTEM
ON
VD
ON
ALARM
Notes:
• To not display the Setup menu for camera output pic-
tures, shift the internal switch. (See page 25.)
• To finalize the settings, press the SETUP/ESC button
for 2 seconds or more while the Setup menu is dis-
played.
• To use the System Controller WV-CU360 for operation,
refer to its Operating Instructions.
Communication Setup for
Camera Communication Mode
1. Display the Setup menu.
2. Move the cursor to COMMUNICATION by pressing
button 1 (C) or button 2 (D). Then press the SUS-
PEND/SET button.
• In case of Camera Communication mode, the
COMMUNICATION
below.
COMMUNICATION
CAM ADDRESS
BAUD RATE
DATA BIT
PARITY CHECK NONE
STOP BIT
WAIT TIME
DELAY TIME
XON/XOFF
3. Move the cursor to the desired item by pressing button
1 (C) or button 2 (D), then select the desired mode by
pressing button 3 (–) or button 4 (+).
4. Press the SUSPEND/SET button.
5. After taking the above steps, press the SETUP/ESC
button for 2 seconds or more.
Note: All the settings must be compatible with the
peripherals connected.
menu appears as shown
19200
8
1
OFF
OFF
NOT USE