SETTING ADDRESSES
Address setting varies from one communication mode to another.
The setting should be made by qualified service personnel or system installers.
Panasonic Security Data Mode
Set each number as follows.
Unit address
of WJ-MP204
Notes:
• Do not set the UNIT switch to position 9 because it is a reserved number.
• When two Units corresponding to Panasonic Security Data or more are connected, check that each UNIT switch is set to a
number different from those of the others.
• In changing unit addresses using the setup menu, set the UNIT switch to position 0.
• Keep the power switch in the OFF position while setting unit numbers. Addresses cannot be set if power is on.
• For details of setting the System Controller WV-CU360, refer to the Operating Instruction for the System Controller.
Setting Unit Addresses
Turn the UNIT switch till the arrow points the desired number.
UNIT
0
Camera Communication Mode
Set camera address as follows.
CAMERA
IN/OUT Connector
Notes:
• Do not set the UNIT switch to position 9 because it is a reserved number.
• When two Units or more are connected, check that each UNIT switch is set to a number different from those of the others.
• In changing camera addresses using the setup menu, set the UNIT switch to position 0.
• Keep the power switch in the OFF position while setting unit numbers. Addresses cannot be set if power is on.
Setting Unit Addresses
Turn the UNIT switch till the arrow points the desired number.
UNIT
0
10
0
1
Set the
number in
1
Setup
menu
0
1
1
1
Set the
2
2
number in
Setup
3
3
menu
4
4
UNIT Switch Settings of WJ-MP204
2
3
4
2
3
4
UNIT Switch Settings of WJ-MP204
2
3
4
5
9
13
6
10
14
7
11
15
8
12
16
5
6
7
5
6
7
5
6
7
17
21
25
18
22
26
19
23
27
20
24
28
8
9
Prohibition
of a Setup
8
(reserved
number)
8
9
29
Prohibition
30
of a Setup
(reserved
31
number)
32