Dip Switch Setting; Setting Communication Mode; Setting The Communication Mode Via Rs485 Or Data Port; Setting The Vs Or Vd Signal Output - Panasonic WJ-MP204 Operating Instructions Manual

DIP SWITCH SETTING

Before connecting the Data Multiplex Unit, check how the
DIP switches are set on the rear panel in cases where the
system setup must be changed.

Setting Communication Mode

Panasonic Security Data Mode
Check that Dip Switches SW3 and SW4 are up.
1 2
Camera Communication Mode
Check that Dip Switch SW3 is down and Dip Switch
SW4 up.
1 2
Setting the Communication
Mode via RS485 or Data Port
Termination
Check that Dip Switch SW5 is down (ON).
Note: In case of using two Data Multiplex Units or
more, set Dip Switch SW5 on only one point at the
end position of the unit to the down position.
9
3 4 5 6
SW3 SW4
3 4 5 6
SW3 SW4
OFF
ON
SW5
Data Line Selection Mode
Set DIP Switch SW6 to the 4-LINE or 2-LINE position
according to the desired data line selection mode.
4-LINE: Full Duplex
2-LINE: Half Duplex
The initial factory setting is 4-LINE.
SW6
Note: Set SW6 to 4-LINE for communication in
Panasonic Security Data mode.
Setting VS or VD Signal Output
Supplying Video Drive Signal in Internal Sync
Mode
*
Check that Dip Switch SW1 is down (VD).
THROUGH
VD
SW1
* Synchronized vertical drive signal is supplied in case
of signal input to VS/VD IN connector.
Supplying Synchronized Signal Input to VS/VD
IN Connector
Check that Dip Switch SW1 is up (THROUGH).
THROUGH
VD
SW1
4-LINE
2-LINE