Displaying The Setup Menu For Panasonic Security Data Mode; Communication Setup Of Panasonic Security Data Mode - Panasonic WJ-MP204 Operating Instructions Manual

Displaying the Setup Menu for
Panasonic Security Data Mode
1. Check that the cameras and peripherals are connected
correctly and securely.
2. Switch all the system components on.
3. Press the SETUP/ESC button for 2 seconds or more.
The Setup menu appears on the monitor.
WJ-MP204 SETUP MENU X.XX
COMMUNICATION
SYSTEM
4. Move the cursor up or down pressing button 1 (C) or
button 2 (D).
5. Press the SUSPEND/SET button. The COMMUNICA-
TION menu or the SYSTEM menu appears on the moni-
tor as shown below.
COMMUNICATION
UNIT ADDRESS 1
BAUD RATE
DATA BIT
PARITY CHECK NONE
STOP BIT
WAIT TIME
ALARM MODE
COMP/VD2/DATA
VS/VD INPUT
CAMERA CONFIG
DAISY MODE
TERMINAL
• The following buttons are used with the Setup menu.
1 (C): To move the cursor down
2 (D): To move the cursor up
3 (–): To select a mode or parameter
4 (+): To select a mode or parameter
SUSPEND/SET: To enter the selections and display
the submenu for the item indicated by the mark
SETUP/ESC: To return to the previous menu
12
9600
8
1
OFF
SYSTEM
ON
VD
ON
ALARM
Note:
• To not display the Setup menu for CAMERA OUT pic-
tures, shift the internal switch.(See page 25.)
• To finalize the settings, press the SETUP/ESC button
for 2 seconds or more while the Setup menu is dis-
played.
• To use the System Controller WV-CU360 for operation,
refer to its Operating Instructions.
Communication Setup of
Panasonic Security Data Mode
1. Display the Setup menu.
2. Move the cursor to COMMUNICATION by pressing
button 1 (C) or button 2 (D).
Then press the SUSPEND/SET button.
• In case of Panasonic Security Data mode, the COM-
MUNICATION menu appears as shown below.
COMMUNICATION
UNIT ADDRESS 1
BAUD RATE
DATA BIT
PARITY CHECK NONE
STOP BIT
WAIT TIME
3. Move the cursor to the desired item by pressing button
1 (C) or button 2 (D), then select the desired mode by
pressing button 3 (–) or button 4 (+).
4. Press the SUSPEND/SET button.
5. After taking the above steps, press the SETUP/ESC
button for 2 seconds or more.
Note: All the settings must be compatible with the
peripherals connected.
• The following buttons are used with the Setup menu for
the WV-CU360. (For Panasonic Security Data mode
only)
UP
L R
L R
: To move the cursor up and down
DOWN
STILL
EL-ZOOM
: To select a mode or parameter
+
-
CAM
: To enter the selections and display
the submenu
SET
MON
: To return to the previous menu
ESC
9600
8
1
OFF