Sequence Setup; System Mode - Panasonic AJ-FX216 Operating Instructions Manual

3. SEQUENCE SETUP

This parameter lets you set the sequential order and
dwell time for camera switching.
1. Move the cursor to SEQUENCE SETUP.
* MENU 3 OF 3 *
BORDER
AUTO SKIP
SEQUENCE SETUP *
START SCREEN

SYSTEM MODE

2. Press button 15 (SET). The SEQUENCE menu
appears on the monitor.
Sequence Number Channel
** SEQUENCE **
1 1CH 2S
2 2CH 2S
3 3CH 2S
4 4CH 2S
5 5CH 2S
6 6CH 2S
7 7CH 2S
8 8CH 2S
3. Move the cursor to the sequence number by press-
(D D C C
ing buttons 9-12 ,
4. Select the channel by pressing button 13 ( ) or 14
(+).
5. Move the cursor to the dwell time by pressing but-
(B B
ton 12 ).
6. Select the desired dwell time by pressing button 13
( ) or 14 (+).
If you select OFF for the dwell time, the selected
channel is automatically skipped.
7. Repeat steps 3 to 6 to determine the sequential
order and dwell time.
8. Press button 15 (SET) to finalize the sequential
order. The display returns to MENU 3 OF 3.
Note: When monitoring a quad picture, the dwell time
indicated for sequence numbers 1-4 refers to that of
the four quad pictures.
WHITE
OFF
1-SEQ
MULTIPLEX
Dwell Time
9 9CH 2S
10 10CH 2S
11 11CH 2S
12 12CH 2S
13 13CH 2S
14 14CH 2S
15 15CH 2S
16 16CH 2S
A A B B
, , ).
4. START SCREEN
This parameter lets you select a display pattern for
your startup screen. When the power is turned on,
the picture is displayed in the selected pattern.
1. Move the cursor to the START SCREEN parameter.
BORDER
AUTO SKIP
SEQUENCE SETUP *
START SCREEN
SYSTEM MODE
2. Select FULL or 1-SEQ.
FULL: A single picture is displayed.
1-SEQ: A sequence of a single picture is displayed.
The factory setting is 1-SEQ.
5. SYSTEM MODE
See "Selecting the system mode" on page 6 for set-
tings and procedures.
-12-
* MENU 3 OF 3 *
WHITE
OFF
1-SEQ
MULTIPLEX