Midas HERITAGE 1000 Operator's Manual page 46

Editing the Cross fade Value of a Scene:
NB When a scene with a cross fade speed is being recalled the display will flash for the specified cross fade time
Halting a Cross fade:
To Pause a crossfade during recall press the CANCEL button. The crossfade can be resumed again by pressing
the CONFIRM button.
Bypassing a Cross fade:
A crossfade can be bypassed by pressing the confirm button as the crossfade is being applied, this will
immediately take you to the finished scene.
Previewing a Scene:
To preview a scene without effecting your mix select the scene number on the display using the ACT/SCENE,
UP and DOWN buttons. Once the desired number is displayed using the CHECK button the automated switch
configuration and fader positions stored for that scene can be viewed without changing the actual settings.
The Automute Safe buttons on the inputs will display the input mute state.
The master VCA mutes will display the Master VCA mute setting with out altering the Audio.
The Group and Matrix Mute Safe buttons will display the checked scene mute status.
The display will also scroll through the other stored scene information, telling you if midi in is enabled and
the channel assigned. The
change number the scene will respond to.
Pressing the CHECK button will drop you back into normal mode.
Recalling Scenes:
There are 3 methods by which scenes can be recalled:
Assigning A Scene To A Fast Scene Key:
Deleting a Scene From A Fast Key:
Deleting A Scene:
a/ Recall the scene you wish to copy by selecting the scene number and pressing the
NOW button.
b/ Press the STORE button, and using the UP and DOWN buttons scroll through the
display until XFADE is shown, press CONFIRM.
c/ The current cross fade speed stored with the screen will be displayed. Using the UP and
DOWN buttons select the required cross fade speed.
d/ Press CONFIRM to store this new speed with the scene.
MIDI out information stored with the scene, cross fade value and program
a/ Stepping through existing scenes using the LAST and NEXT buttons. This steps
through the scenes in numerical order.
b/ Select the act/scene number using the ACT/SCENE, UP and DOWN buttons, when the
correct scene number is displayed in the screen press the NOW button and the scene
will be recalled.
c/ A scene can be assigned to a fast scene key (1-10). In this instance the scene is recalled
by just pushing the fast scene key.
a/ Recall the scene you wish to assign to a FAST SCENE KEY.
b/ Press the COPY button, followed by the FAST SCENE KEY button you wish to assign
that ACT/SCENE to. The screen will then display
a/ Press and hold down the FAST KEY you want to delete.
b/ When the YES and NO button start to flash you can now select either YES or NO to
delete or cancel deletion of the FAST KEY.
Recall the scene you wish to delete, Or display the scene number on the screen using the
ACT/SCENE, UP and DOWN buttons. When this is done press the DELETE button.
You will be asked to confirm this. Press the CONFIRM button the screen will then say
done when the scene is deleted.
done
36
.