Table of Contents
Advertisement
Note:
To complete QoS function configuration, you have to go to the Schedule Mode page to select a
schedule mode after the configuration is finished on this page.
Configuration Procedure:
Step Operation
1
Log on to the Port Priority
page
2
Select the desired ports for
configuration
3
Select the port priority
4
Select a schedule mode
9.1.2 Schedule Mode
On this page you can select a schedule mode for the switch. When the network is congested, the
problem that many packets complete for resources must be solved, usually in the way of queue
scheduling. The switch will control the forwarding sequence of the packets according to the priority
queues and scheduling algorithms you set. On this switch, the priority levels are labeled as TC0,
TC1... TC3.
Choose the menu QoS→DiffServ→Schedule Mode to load the following page.
The following entries are displayed on this screen:
Schedule Mode Config
SP-Mode:
WRR-Mode:
Description
Select the desired ports. It is multi-optional.
Required. Select a priority from CoS0 to CoS7.
Required. Log on to the Schedule Mode page to
select a schedule mode.
Figure 9-7 Schedule Mode
Strict-Priority Mode. In this mode, the queue with higher priority
will occupy the whole bandwidth. Packets in the queue with lower
priority are sent only when the queue with higher priority is empty.
Weight Round Robin Mode. In this mode, packets in all the queues
are sent in order based on the weight value for each queue. The
weight value ratio of TC0, TC1, TC2 and TC3 is 1:2:4:8.
127
Advertisement
Table of Contents
