TP-Link TL-SL5428E User Manual page 112

Configure Switch D:
Step Operation
1 Configure ports
2 Enable STP function
3 Configure the region name and
the revision of MST region
4 Configure
mapping table of the MST region
The configuration procedure for switch E and F is the same with that for switch D.
The topology diagram of the two instances after the topology is stable
For Instance 1 (VLAN 101, 103 and 105), the red paths in the following figure are connected
links; the gray paths are the blocked links.
For Instance 2 (VLAN 102, 104 and 106), the blue paths in the following figure are connected
links; the gray paths are the blocked links.
Description
On VLAN→802.1Q VLAN page, configure the link type
of the related ports as Trunk, and add the ports to VLAN
101 and VLAN 106. The detailed instructions can be
found in the section 802.1Q VLAN.
On Spanning Tree→STP Config→STP Config page,
enable STP function and select MSTP version.
On Spanning Tree→STP Config→Port Config page,
enable MSTP function for the port.
On Spanning Tree→MSTP Instance→Region Config
page, configure the region as TP-LINK and keep the
default revision setting.
VLAN-to-Instance On
Config page, configure VLAN-to-Instance mapping
table. Map VLAN 101, 103 and 105 to Instance 1; map
VLAN 102, 104 and 106 to Instance 2.
Spanning Tree→MSTP
104
Instance→Instance