Operating Sequence; Washing Only - Zanussi ZKI 245 User Manual

This function remains able also when the
washer-dryer is not working.
To enable (disable) this option press
simultaneously for about 6 seconds buttons
3
and buttons until the icon
(disappears) on (from) the display.
Operating sequence - Washing only
possible. Close the door.
2. Measure out the detergent and the fabric
softener
Pull out the dispenser drawer until it stops.
Measure out the amount of detergent required,
pour it into the main wash compartment
and, if you wish to carry out a programme with
the prewash, pour it into the compartment
marked .
If required, pour fabric softener into the
compartment marked
must not exceed the «MAX» mark in the
drawer). Close the drawer gently.
Select the required programme by means of
the programme selector dial
Turn the programme selector dial to the
required programme. The green light of button
8
starts to flash. It can be turned either
clockwise or anticlockwise.
On position «O» the programme is reset and
the machine is switched off.
12
2
appears
1. Load the laundry
Open the door by
carefully pulling the
door handle outwards.
Place the laundry in the
drum, one item at a
time, shaking them out
as much as
(the amount used
(1)
There are two different ways to set this option:
before pressing the button
●
it will be impossible to start the machine.
after pressing the button
●
it will be impossible to change any other
programme or option.
At the end of the programme the selector
dial must be turned to position «O», to
switch the machine off.
ATTENTION!
If you turn the programme selector dial to ano-
ther programme when the machine is working,
the red pilot light of button
and the message Err is displayed on the dis-
play to indicate a wrong selection. The machi-
ne will not perform the new selected program-
me.
Select the spin speed or the Rinse Hold
option by pressing button
When selecting a programme, the light
corresponding to the maximum speed allowed
for that programme will illuminate. The relevant
light will light up.
Select the desired option by pressing
3 4 6
buttons , and
Depending on the programme, different
functions can be combined. These must be
selected after choosing the desired programme
and before depressing the button
For the compatibility of the options with the
washing programmes, refer to the section
«Programmes table».
Select the delayed start by pressing the
10
button
Press this button to select the required delay.
The selected delay time value will appear on
the display for a few seconds, then the duration
of the programme will appear again.
You must select this option after you have set
the programme and before you press the
8
:
8:
8
will flash 3 times
2
8
.