Zanussi ZKI 245 User Manual page 13

8
button .
You can cancel the delay time at any moment,
before you press button
pressed it, and you wish to cancel the delay
time, proceed as follows:
• set the washer-dryer to PAUSE by pressing
8
button ;
10
• press the button
appear the symbol «
8
• press button again to start the programme.
IMPORTANT!
• The selected delay can be modified only after
you have turned the programme selector dial
to the «O» position and after you have
selected the programme again.
• The door will be locked throughout the delay
time. If you need to open the door, you must
first set the washer-dryer to PAUSE by
8.
pressing button The door can be opened
immediately or after a few minutes depending
on the model. (In any case do not try to open
the door if it is locked!). After you have closed
the door, press the same again.
Note!
The Delay Start cannot be selected with
«Drain» programme.
Start the programme by pressing button
To start the selected programme, press this
button; the corresponding green pilot light
stops flashing.
9
The pilot light illuminates to indicate that the
appliance starts operating and the door is
locked.
If a delayed start has been selected, the
display shows the countdown.
IMPORTANT!
If an option which is not compatible with the set
wash programme is selected, the message Err
is displayed for a few seconds and the red light
of this button flashes for 3 times.
Altering an option or a running programme
It is possible to change some options before
the programme carries them out.
8
. If you have already
once. On the display will
0'
».
Before you make any change, you must pause
the washer-dryer by pressing button
Changing a running programme is possible
only by resetting it. Turn the programme
selector dial to «O» and then to the new
programme position. Start the new programme
by pressing button
The washing water in the tub will not empty out.
Interrupting a programme
Press the button
which is running, the corresponding light starts
to flash. Press the button again to restart the
programme.
Cancelling a programme
Turn the selector dial to «O» to cancel a
programme which is running. Now you can
select a new programme.
Opening the door after the programme has
started
First set the machine to pause by pressing the
8
button . If the light
be opened immediately or after a few minutes
depending on the model.
If it does not switch off, this means that the
machine is already heating or that the water
level is too high. In this cases the door cannot
be opened.
8
If you cannot open the door but you need to
open it you have to switch the machine off by
turning the selector dial to «O». After a few
minutes the door can be opened
(Pay attention to the water level and
temperature!). After this procedure, it will be
necessary to set the programme and the
options again and then to press button
At the end of the programme
The machine stops automatically. Some
acoustic signals sound and on the display will
appear a flashing «
9
and the light
opened.
If at the end of a programme there is water in
the tub, the light
locked to indicate taht the door must be empty
out.
8
again.
8
to interrupt a programme
9
goes off, the door can
0
». The light of button
go off. The door can be
9
remains on and the door is
8
.
8
.
8
13