Unscrew the hose from the machine. Keep a
●
rug nearby because some water may flow.
Clean the filter in the valve with a stiff brush
●
or with the piece of cloth.
Screw the hose back to the machine and
●
make sure the connection is tight.
Turn on the water tap.
●
The dangers of freezing
If the machine is exposed to temperatures
below 0°C, certain precautions should be taken.
Turn off the water tap.
●
Unscrew the inlet hose.
●
Place the end of the emergency emptying
●
hose and that of the inlet hose in a bowl
placed on the floor and let water drain out.
Screw the water inlet hose back on and
●
What to do if...
IMPORTANT!
Certain problems are due to lack of simple maintenance or oversights, which can be solved easily
without calling out an engineer. Before contacting your local Service Centre, please carry out the
checks listed below.
During machine operation it is possible that the red pilot light of button
signals sound and one of the following alarm codes appears on the display to indicate that the
machine is not working:
E10
: problem with the water supply
●
E20
: problem with water draining
●
E40
: door open.
●
Once the problem has been eliminated, press the button
checks, the problem persists, contact your local Service Centre.
18
Clean the filter in the
●
hose using a hard
bristle brush.
Screw the hose back
●
onto the tap.
reposition the emergency emptying hose
after having put the cap on again.
When you intend to start the machine up
●
again, make sure that the room temperature
is above 0°C.
Emergency emptying out
If the water is not discharged, proceed as
follows to empty out the machine:
pull out the plug from the power socket;
●
close the water tap;
●
if necessary, wait until the water has cooled
●
down;
place a bowl on the floor and place the end
●
of the emergency emptying hose into the
bowl. Remove its cap. The water should
drain by gravity into the bowl. When the bowl
is full, put the cap back on the hose. Empty
the bowl. Repeat the procedure until water
stops flowing out;
clean the pump if necessary as previously
●
described;
replace the emergency emptying hose in its
●
seat after having plugged it;
screw the pump cover again.
●
8
8
to restart the programme. If after all
flashes, a few acoustic