Zanussi ZKI 245 User Manual page 24

5. Fill the smaller upper hole and the two large
ones with the corresponding plastic plug
caps supplied in the bag containing the
instruction booklet.
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the
machine is not impeded by carpets, rugs etc.
Before placing it on small tiles, apply a rubber
coating.
Never try to correct any unevenness in the
floor by putting pieces of wood, cardboard or
similar materials under the machine.
If it is impossible to avoid positioning the
machine next to a gas cooker or coal-burning
stove, an insulating panel covered with
aluminium foil on the side facing the cooker or
stove, must be inserted between the two
appliances.
The machine must not be installed in rooms
where the temperature can drop below 0.
The water inlet hose and the drain hose must
not be kinked.
Please ensure that when the appliance is
installed, it is easily accessible for the engineer
in the event of a breakdown.
Carefully level by screwing the adjustable feet
in or out. Never place cardboard, wood or simi-
lar materials under the machine to compensate
for any unevenness in the floor. After having
levelled the machine, tighen the lock nuts.
24
Installation on suspended flooring
Suspended wooden floors are particularly
susceptible to vibration.
To help prevent vibration we recommend you
place a waterproof wood panel, at least 15
mm thick under the appliance, secured to at
least 2 floor beams with screws, the wood
panel must extend beyond the front feet.
If possible install the appliance in one of the
corners of the room, where the floor is more
stable.
Rubber feet kit (4055126249)
Available from your authorized dealer.
The rubber feet are particularly recommended
on floating, slippery and wooden floors.
Mount the rubber feet to prevent vibration,
noises and displacement of the appliance
during operation.
Read carefully the instructions supplied with
the kit.
Water inlet
The inlet hose is already screwed on the back
of the appliance.
1. Set the hose correctly by loosening the ring
nut. After positioning the inlet hose, be sure
to tighten the ring nut again to prevent
leaks.
Attention!
Do not place the inlet hose downwards.
Angle the hose to the left or right
depending on the position of your water tap
(see picture).
2. Connect the hose
with the angled
connection to the
machine.